The Edges
Rolled edging material in use is set to individual support. They are used to glue a thin piece of plastic on the non-rectangular shapes, but can be mounted on the table and work as a landline. Removing overhangs edging material produced during Veneering such devices is performed manually, using special devices: longitudinal – in the form of a guillotine, and overhangs on the plate – having the form of strips with an angular slot, inside of which is equipped with two knife cutoff overhang and form a bevel on the edges of the workpiece. A classic machine for edge banding detail rectangular shape is the one that was first developed by Italian firm Fravol in 1963, on stand which is a table and set to glue the edges – with a cup of granulated glue to melt, or with a hair dryer to heat the glue, pre-deposited onto the edging material. Removing overhangs produced or special units to be installed on his desk and bed, or on a separate machine to remove the overhang. For very small businesses by some manufacturers produced simple machines in which there is only node for edge banding and a device for removing it overhangs on layer blank stationary blades, and removal of end overhangs then performed manually. Filing blanks in such machines is already driven chain conveyor to which they are pressed V-belt. In fact, they repeat the construction of the very first edge banding machine, developed more than forty years ago. All this equipment can not be meet the needs of businesses large enough power and used them as an additional example, in their experimental plots – they require other tools, in more serious equipment.